Call +60133250836

Free Shipping on All Orders Over RM 150

Your trusted source for all cell phone signal solutions

3G RF Repeater Mobile Phone Signal Booster Amplifer Kit + Outdoor Yagi Antenna (10m Cable)


  • Can cover up to 3000 sq ft with a strong existing outside signal

  • Covers all major 3G carriers

  • Complete kit comes with everything you need to get started.

Availability: In stock

RM450.00
RM450.00
We're Here to Help!

We provide the best sales and support for our clients

  Call +60133250836



Money Back Guarantee


Expert Installation Assistance


Description

Details

The 3G RF Repeater Mobile Phone Signal Booster Amplifer with Yagi Directional Antenna is one of the most powerful signal boosters available that has been certified under the new FCC regulations. It is perfect for situations where you have a weak outside signal and need a high powered antenna to target your carrier's nearest cell tower and maximize the coverage area inside of the home or office. This kit boosts the frequencies used for voice calls and 3G data by the major carriers in Malaysia, and includes everything you need to get started. Please note that this kit will not boost the 4G LTE frequencies used for broadband speed data by any of the carriers.

Coverage Area

Many variables impact the total coverage area of a signal booster system. The following are estimates only and may not be accurate in any individual situation.

  • If you have an existing strong 5-bar outside signal, you may get up to 3000 sq ft of coverage inside*
  • If you have an existing 3 to 4-bar (-90 dB) outside signal, you may get up to 2000 sq ft of coverage inside*
  • If you have an existing 1 to 2-bar (-100 dB) outside signal, you may get up to 1000 sq ft of coverage inside*

Supported Carriers

The 3G RF Repeater Mobile Phone Signal Booster Repeater Kit for Voice 3G boosts the standard frequencies of 2100 MHz which are widely used in Malaysia. The following carriers are supported:

  • Celcom 3G
  • Maxis 3G
  • Digi 3G
  • Umobile 3G

This system does not support 4G LTE, WiMAX, Nextel/iDEN/MIKE, or AWS networks.

Kit Includes

The 3G RF Repeater Mobile Phone Signal Booster Repeater Kit with everything needed in one box. Some installations may require additional parts so see the Accessories section below.

  • 3G Booster Host Amplifier
  • 3G High Gain Yagi Antenna
  • Internal panel antenna
  • RG58 coaxial cables (10 meter cable)
  • Instruction manual

 

Installation Overview

The 3G RF Repeater Mobile Phone Signal Booster Repeater Kit is easy to install for anyone that's a bit handy. But if you're not comfortable getting up on your roof to mount an antenna, it may be best to find an electronics installer or a handy friend. We always recommend doing a soft install where you don't permanently mount anything or drill any holes until you know the system will work for you and you've identified the best locations for the antennas. To install, just follow these 4 steps:

  1. To start, you'll need to find a place on the roof of your home or office to mount the outside antenna. With a directional outside antenna, it's best to figure out which direction it will need to be pointed before permanently mounting the antenna which we'll cover at the end. Connect the RG58 coaxial cables to the antenna and run it into the building. You may be able to enter through a vent or a soffit; otherwise, you may have to drill a hole.

  2. With the cable inside to the amplifier. To the inside antenna port on amplifier, connect the RG58 coaxial cables and then connect the inside antenna.

  3. Once all of the components are connected, plug in the amplifier and see if you get any error lights. For any errors, consult the manual or contact us for help.

  4. For best results, you'll need to aim the directional outside antenna. Start with the antenna high on the roof pointed in one direction. Turn on the system and have an inside helper inside stand about 3 ft. from the inside antenna and take a signal reading with led display and their phone in field test mode. Rotate the directional antenna 45 degrees and then pause for 30 to 60 seconds. After the pause, the person inside should take another signal reading, and then you can repeat the process. Each time your partner checks the signal strength, also check to make sure there aren't any warning lights on the amplifier. After you've gone all the way around, mount the antenna facing in the direction with the strongest signal. If possible, also mount the antenna on that side of the home or office so that it's pointing away from the building and not over the building.

The included manual is very helpful and we recommend reading through it before beginning the installation. If you run into any issues, feel free to contact us for help.


* The actual coverage area of a signal booster is dependent on many factors including existing outside signal strength, obstructions between you and the cell tower, the materials used in your home or office, the layout of the area you need to cover with a boosted signal, and other factors. The approximate coverage areas listed above are estimates. Actual coverage area will vary based on these and other factors. If you're not sure if a system will be powerful enough for your needs, contact us to find out.

Additional Info

Additional Info

Frequency Bands 2100Mhz

Reviews

Excellent seller!Review by Bob
Fast Shipping (Posted on 3/20/16)

Write Your Own Review

You're reviewing: 3G RF Repeater Mobile Phone Signal Booster Amplifer Kit + Outdoor Yagi Antenna (10m Cable)

Tags

Tags

Use spaces to separate tags. Use single quotes (') for phrases.